← Back

Local Reviews
for Mather, CA

Huft Home Services Rated 5.0 out of 5 stars based on 1 customer reviews

Map of Mather, CA

great service




Review of Huft Home Services

I am happy with the company.


Bradley M.

Bradley M.

Replaced control board to allow for proper unit operation. Tested. Cycled heat several times. System is operational at this time.

Near Monhegan Way, Mather, CA 95655
Bradley M.

Bradley M.

Upon arrival system not operational. Control Board in lockout for failed ignition. Reset board. System fired up and then dropped out after a few seconds. Inspected flame sensor. Flame sensor ok. Inspected control board. Several cracked solder joints on the back of 12 pin connector. Readjusted plug and unit fired up and completed sequence of operation. Cycled several times. Issue is intermittent. Control board is failing. Hot surface igniter is testing at 60 ohms. Blower motor is operational and not leaking a visible amount of oil at this time. Signed on club membership for routine maintenance and savings.

Near Monhegan Way, Mather, CA 95655
Shuntavious O.

Shuntavious O.

Checked a Bosch system System did not duplicate sound that client heard before I arrived system is operational at this time told client if system makes noise again to try to record it and give us a call

Near Ivoryton Way, Mather, CA 95655
Andre B.

Andre B.

Performed heating tuneup for carrier split system. Checked all safeties and connections. Checked filter. System is operational at this time. Renewed on super hero club membership and has two more visits left. Will also order damper motors and return to replace at a later date.

Near Nestlenook Cir, Mather, CA 95655
Miguel R.

Miguel R.

Performed heat maintenance on York diamond 80 furnace. Cleared inducer port and gas orifices. Cleaned burners and flame sensor. Checked all electrical. Everything within spec. System is operational and heating at this time

Near Monhegan Way, Mather, CA 95655
Kenneth B.

Kenneth B.

Remove existing equipment and haul away. Install new Trane 4 Ton XR17/XV80 16 SEER, 80% furnace (2 Stage). Reconnect condensate lines and verify flow to the exterior and add condensate safety switch. Install new electrical dis-connect at condenser with properly sized fuses and weatherized whip. Install new Hi Flo return. Remove registers, manually seal boots and install new hi-flow registers. Upgrade to MERV 13 5” inch filter. HERS certification includes third party duct pressure test. Freon recovery per EPA regulations. Installation includes equipment,material, labor, all required testing, taxes permits. Installation total $13,527.00 Due on completion - $13,527.00

Near Kingscote Way, Mather, CA 95655
Chuc N.

Chuc N.

Found a bad in zone sensor to upstairs. Replaced the in zone sensor. System operations ok at this time

Near Essey Cir, Mather, CA 95655
Kris D.

Kris D.

Conducted permit corrections. Re-did condensates to display purple primer, phase taped wire in the disconnect for air handler. Customer had dealt with the malfunctioning smoke detectors on his own. Also opened damper for master bedroom.

Near Ivoryton Way, Mather, CA 95655
Miguel R.

Miguel R.

CAll for no ac. System was operational upon arrival. Ran system for 20 minutes with no problems. Checked electrical and refrigerant levels. Everything within spec. System is operational

Near Essey Cir, Mather, CA 95655
Kris D.

Kris D.

Gave options for Trane and Bosch 4 Ton units

Near Kingscote Way, Mather, CA 95655